Baby Overgarment Basic Pattern Calculator

Recommended age group for the baby over-garment pattern is 0-2 years old (56-92 cm).
The baby overgarment block allows you to create any designs you want: jackets, coats, etc.
Fabric recommendations: any fabric you want.

Instructions for using the pattern calculator:
* Add your measurements in the yellow cells from the "MEASUREMENTS" tab. The basic measurements needed for the pattern should be made by using the sketch from the same sheet and the measurement code (ex. A, B, C, etc.)
* Press button "Calculate"
* In the "RESULTS/INSTRUCTIONS" tab, the dimensions for the blocks will be computed automatically.
By following the steps from "RESULTS/INSTRUCTIONS" and the drawing you will be easily able to make your own pattern. Good luck!

Measurements	Code	Value [cm]
		FILL IN
Chest circumference:	B
Back width:	E
Neck circumference:	F
Scye depth:	K
Back length:	L
Arm length:	H
Measured segments
Back armhole line (15-13-8):
Garment measurements
Overgarment length:

Line	Value [cm]	Instructions
		Back
0		Square down and right from point 0.
0-F	24.0	Square right from point F.
0-W	18.2	Square right from point W.
0-B	14.2	Square right from point B.
0-N	1.5
N-A	6.3	Square right from point A.
N-S	0.5	Square right from point S.
0-N2	5.5	Draw the back neckline by connecting points N-N2 with a curved line.
B-B3	12.5	Square up from point B3 and mark points A3 and 1.
1-S3	0.8	Connect points N2 and S3.
B-B2	16.8	From point B2, square down and mark points W2 and F2.
		Draw the back armhole line through points S3, A3, B2.
		Front
0-N1	5.7	Draw the front neckline.
		Sleeve
S3		Square down from point S3.
S3-F3	19.0	Square left from point F3.
S3-B3	5.3	Square left from point B3.
S3-B2	14.0	It is equal to the length of the back armhole line S3-A3-B2.
F3-F2	8.6	Connect points F2 and B2.
6 parts	2.3	Divide the segment S3-B2 into 6 equal parts; mark points 1, 2, 3, 4, 5.
		Sleeve head: on the line S3-B2 square down and up from points 1 and 4, 0.3cm (a) and 1cm (b) respectivley. Draw the sleeve head through points B2, tip of the perpendicular (a), 2, tip of the perpendicular (b) and S3.